双纠缠原子在耗散腔场中的纠缠动力学

研究了能量损耗腔中,两纠缠二能级原子与单模辐射场相互作用过程中原子的纠缠动力学.结果表明:双纠缠原子的纠缠度演化特性决定于初始两原子间的纠缠度、纠缠形式、腔场的平均光数、腔场的衰变系数.当原子初始处于一特定纠缠态时,其纠缠度可以放大,并且不受腔场损耗的影响. 关键词： 二能级原子 纠缠度 密度算符 单模辐射场     

8 mm回旋行波管和返波管的三折螺旋波纹波导色散分析

 三折螺旋波纹波导使TE11模和TE21模相互耦合，其色散曲线能够在宽频带内与电子回旋共振，因此需要对色散方程进行研究。提出了适合工程实用的行波模式和返波模式的色散方程，并对方程中的耦合系数进行了简化，误差在1%左右。利用CST软件的VBA语言对螺旋波纹波导进行建模和计算，根据模拟得到的传输特性曲线的特点，提出一种模拟方法，将模拟与理论计算得到的色散曲线作对比，误差在5%左右。     

Combined effect of PMD and PDL on four-wave-mixing-induced crosstalk in WDM system

We derive an explicit autocorrelation function (ACF) formula of state of polarization for a fiber transmission system with polarization mode dispersion (PMD) and polarization dependent loss (PDL), which is found to agree well with Monte Carlo simulation. Then we use the new ACF to investigate the combined effect of PMD and PDL on the polarization multiplexed scheme. We find the performance of the polarization multiplexed scheme can be deteriorated more severely than the case without PDL.     

An Efficient Numerical Model for Planar Spiral Inductor On-Chip

In this paper, a very useful numerical technique has been developed for analyzing the transient characteristics of a planar-spiral inductor on-chip. A locally conformal technique and an alternating-direction implicit scheme are applied to the finite-difference time-domain method. A formulation for solving three dimensional Maxwell’s equations is proposed. Using the proposed method, various parameters of the planar-spiral inductors have been analyzed and an equivalent circuit, which includes frequency-independent circuit elements, has been introduced. Highly computational efficiency is implemented. Numerical results show excellent agreement with the measured data over a wide frequency range.     

滤波器对偏振模色散的补偿

根据耦合非线性薛定谔方程 ,本文研究了偏振模色散如何影响各种码型的频谱 ,分析了滑频滤波器和固定滤波器对偏振模色散的补偿作用。研究结果表明 :偏振模色散对不同码型的频谱影响是不一样的 ,对色散管理孤子的频谱影响最大 ,产生新的频率分量也最多 ,而且每个新频率分量都较强 ,比入射频谱展宽许多 ;滑频滤波器和固定滤波器对偏振模色散都具有补偿作用 ,使最大可传输距离成倍增加 ,两种滤波器对偏振模色散的补偿作用相差较小 ;但是对色散管理孤子系统中的偏振模色散补偿效果最佳。     

Density-Functional Theory Calculations of Normal Modes and Raman Intensities for Tetraazaporphin

The structure, harmonic frequencies, and nonresonance Raman intensities for porphin, tetraazaporphin (TAP), and three of its isotopomers are calculated by the density-functional theory of B3LYP/6-31G(d). Scaling of force constants for porphin in nonredundant natural coordinates is performed. The scaling factors obtained were used to predict the force field and normal modes of TAP and three of its isotopomers. Two alternative methods are used to carry out reliable assignment of the TAP frequencies: wavenumber-linear scaling method and frequency-shift method. There is good agreement between the frequencies predicted within the framework of the three methods used. The conservativeness of the out-of-plane B _2g - and B _3g -modes for porphin and TAP is examined. The Raman spectrum for TAP is simulated. A refinement of the assignment of the experimental frequencies for TAP of even symmetry types on the basis of the calculations performed is made.     

LINEAR ACTIVE STRUCTURES AND MODES (Ⅱ)--DISCRETE SYSTEMS AND BEAMS

The basic concepts about the active structures and some attributes of the modes were presented in paper "Liner Active Structures and Modes ( Ⅰ ) ". The characteristics of the active discrete systems and active beams were discussed, especially, the stability of the active structures and the orthogonality of the eigenvectors. The notes about modes were portrayed by a model of a seven-storeyed building with sensors and actuators. The concept of the adjoint active structure was extended from the discrete systems to the beams that were the representations of the continuous structures. Two types of beams with different placements of the measuring and actuating systems were discussed in detail. One is the beam with the discrete sensors and actuators, and the other is the beam with distributed sensor and actuator function. The orthogonality conditions were derived with the modal shapes of the active beam and its adjoint active beam. An example shows that the variation of eigenvalues with feedback amplitude for the homo-configuration and non-homo-configuration active structures.     

Dynamic surface tension measurements of surfactant solutions using the maximum bubble pressure method – limits of applicability

One of the essential differences in the design of bubble pressure tensiometers consists in the geometry of the measuring capillaries. To reach extremely short adsorption times of milliseconds and below, the so-called deadtime of the capillaries must be of the order of some 10 ms. In particular, for concentrated surfactant solutions, such as micellar solutions, short deadtimes are needed to minimize the initial surfactant load of the generated bubbles. A theoretical model is derived and confirmed by experiments performed for a wide range of experimental conditions, mainly in respect to variations in deadtime and bubble volume.     

反射式微光机电系统(MOEMS)的研究现状与展望

反射式微光机电系统是微光机电系统中的重要组成部分,近年来得到了较快的发展。介绍了反射式微光机电系统(MOEMS)的研究现状和最新进展。根据反射式微光机电系统的分类,列举了一些具有代表性的反射式MOEMS器件。简要介绍了反射式MOEMS的加工工艺;阐述了反射式MOEMS的应用领域;展望了发展前景。     

一种新颖的用于光腔模式及光束传输模拟的特征向量法

根据有限元法单元划分的思想，提出了一种新颖的模拟光腔模式及光束传输的特征向量法. 该方法的关键之处在于基于衍射积分理论构造了一种新的光束传输矩阵，通过求解特征矩阵方程可一次性得到谐振腔的一系列特征向量，每一列特征向量即代表了腔镜上光场的一个确定模式的振幅及相位分布. 并可采用该方法模拟光场传输到腔内或腔外任意地方的场分布. 该方法将传统方法中大量的迭代过程转化成为本征积分方程特征向量的求解过程，并与初值取值无关，且可一次性求得多个模式分布，从而可方便地分析谐振腔的模式鉴别能力. 特征向量法对圆形镜共焦 关键词： 谐振腔 特征向量法 模式分布